GSO ISO 3739-3:2010
Gulf Standard
Current Edition
·
Approved on
31 October 2010
·
Industrial tyres and rims -- Part 3: Rims
GSO ISO 3739-3:2010 Files
English
8 Pages
Current Edition
Reference Language
You can buy this standard from any member store
GSO ISO 3739-3:2010 Scope
ISO 3739-3:2008 specifies the main requirements, including size designation and marking, of 5° tapered and flat base rims, with diameters not exceeding rim diameter code 15 for pneumatic tyres and for solid tyres for pneumatic tyre rims, primarily intended for industrial vehicles for use on prepared surfaces.
ISO 3739-1 gives the designation, dimensions and marking, and ISO 3739-2 gives the load ratings, of pneumatic tyres (metric series). ISO 10499-1 covers the designation, dimensions and marking of rubber solid tyres (metric series) for pneumatic tyre rims.
Rim dimensions are specified for size and contour only. The tyre and wheel/rim manufacturers are consulted for confirmation of the suitability of the tyre/rim combinations, particularly with regard to rim profile and wheel strength
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
GSO 98:1988
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF
INTERIOR MATERIALS AND THEIR
TESTING METHODS
GSO 1780:2010
Gulf Technical Regulation
Motor vehicle-vehicle identification number (vin) - requirements
Recently Published from Mechanical Sector
GSO ASTM D4778:2024
ASTM D4778:15
Gulf Standard
Standard Test Method for Determination of Corrosion and Fouling Tendency of Cooling Water Under Heat Transfer Conditions (Withdrawn 2024)
GSO ISO 24513:2024
ISO 24513:2019
Gulf Standard
Service activities relating to drinking water supply, wastewater and stormwater systems — Vocabulary
GSO EN 14622:2024
EN 14622:2005
Gulf Standard
Devices to prevent pollution by backflow of potable water - Air gap with circular overflow (restricted) - Family A, type F
GSO ISO 21384-2:2024
ISO 21384-2:2021
Gulf Standard
Unmanned aircraft systems — Part 2: UAS components