GSO ISO 14278:2013
ISO 14278:2002
Gulf Standard
Current Edition
·
Approved on
09 September 2013
Aerospace -- Gauges, for internal offset cruciform ribbed or unribbed drives -- Metric series
GSO ISO 14278:2013 Files
English
8 Pages
Current Edition
Reference Language
You can buy this standard from any member store
GSO ISO 14278:2013 Scope
This International Standard specifies the dimensions of metric gauges which check internal offset cruciform drives, ribbed or unribbed, used in metric screws in the nominal thread diameter range of 1,6 mm to 20 mm.
The internal offset cruciform drives, ribbed drives and unribbed, respectively are defined in ISO 14275 and ISO 14276.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
GSO 98:1988
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF
INTERIOR MATERIALS AND THEIR
TESTING METHODS
GSO 1780:2010
Gulf Technical Regulation
Motor vehicle-vehicle identification number (vin) - requirements
Recently Published from Mechanical Sector
GSO EN 13445-6:2024
EN 13445-6:2021
Gulf Standard
Unfired pressure vessels - Part 6: Requirements for the design and fabrication of pressure vessels and pressure parts constructed from spheroidal graphite cast iron
GSO ISO 11154:2024
ISO 11154:2023
Gulf Standard
Road vehicles — Roof load carriers
GSO ISO 10468:2024
ISO 10468:2023
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes
— Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors
Select GSO Member Stores
