GSO ISO 3877-1:2013
ISO 3877-1:1997
Gulf Standard
Current Edition
·
Approved on
09 September 2013
Tyres, valves and tubes -- List of equivalent terms -- Part 1: Tyres
GSO ISO 3877-1:2013 Files
English
23 Pages
Current Edition
Reference Language
You can buy this standard from any member store
GSO ISO 3877-1:2013 Scope
This part of ISO 3877 presents a list of equivalent tyre terms commonly used in the tyre industry.
The terms are arranged in three columns. The first column gives the English terms in alphabetical order. The second column gives the English terms used in the USA and it should be noted that such terms are not necessarily in alphabetical order. An alphabetical index of the English (USA) terms is located at the end of this part of ISO 3877. The third column gives the equivalent French terms.
In each column, synonyms are separated by a semicolon (;).
Some of the basic terms relating to tyres are illustrated in figures 1 and 2.
Definitions of some terms presented in this part of ISO 3877 are given in ISO 4223-1 and ISO 4223-2. For terms relating to wheels/rims and definitions, see ISO 3911.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
GSO 98:1988
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF
INTERIOR MATERIALS AND THEIR
TESTING METHODS
GSO 1780:2010
Gulf Technical Regulation
Motor vehicle-vehicle identification number (vin) - requirements
Recently Published from Mechanical Sector
GSO EN 13445-6:2024
EN 13445-6:2021
Gulf Standard
Unfired pressure vessels - Part 6: Requirements for the design and fabrication of pressure vessels and pressure parts constructed from spheroidal graphite cast iron
GSO ISO 11154:2024
ISO 11154:2023
Gulf Standard
Road vehicles — Roof load carriers
GSO ISO 10468:2024
ISO 10468:2023
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes
— Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors