GSO ISO 13043:2013

ISO 13043:2011
Gulf Standard   Current Edition · Approved on 09 September 2013

Road vehicles -- Refrigerant systems used in mobile air conditioning systems (MAC) -- Safety requirements

GSO ISO 13043:2013 Files

English 21 Pages
Current Edition Reference Language

GSO ISO 13043:2013 Scope

This International Standard is restricted to refrigerant systems providing cooling or heating of passenger compartment, battery, etc., in passenger motor vehicles. It provides minimum design requirements for refrigerant containment and safety requirements of these systems. This International Standard addresses the use of only R-134a, R-1234yf and R-744 refrigerants in vehicle original equipment manufacturer (OEM) and aftermarket (non-OEM) supplied components and systems. The relevant risks associated with these refrigerant systems are: — projection of fragments or fluid due to high pressure systems; — inhalation of toxic substances, including potential decomposition products; — flame propagation. Consequently, this International Standard will address the component and system design requirements related to any of these hazards where the refrigerant system is involved. Any scenario involving other components from the heating, ventilation and air conditioning (HVAC) system (heater, blower, air mixing and distribution) or any other component of the vehicle not related to the refrigerant system will not be covered in this International Standard. The purpose of this International Standard is to ensure that end-users or service technicians are not exposed to hazards during normal usage, maintenance and repair, and end-of-life disposal of the car. Therefore, manufacturing, storage and transportation of the refrigerant, as well as refrigerant distribution and filling machines in the assembly plant will not be covered in this International Standard. For these situations, the safety of qualified personnel will be addressed by existing standards commonly used among the industry and relevant regulations. Entire vehicle lifetime has been considered to address durability issues. For the R-134a system, this International Standard applies to any new model type launched one year after the document is published. For the R-1234yf and R-744 systems, this International Standard applies from first application of these refrigerants to any vehicle

Best Sellers From Mechanical Sector

GSO 42:2015
 
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
 
Gulf Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS
GSO 98:1988
 
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF INTERIOR MATERIALS AND THEIR TESTING METHODS
GSO 1780:2010
 
Gulf Technical Regulation
Motor vehicle-vehicle identification number (vin) - requirements

Recently Published from Mechanical Sector

GSO EN 13445-6:2024
EN 13445-6:2021 
Gulf Standard
Unfired pressure vessels - Part 6: Requirements for the design and fabrication of pressure vessels and pressure parts constructed from spheroidal graphite cast iron
GSO ISO 11154:2024
ISO 11154:2023 
Gulf Standard
Road vehicles — Roof load carriers
GSO ISO 10468:2024
ISO 10468:2023 
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes — Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023 
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors