GSO ISO 7805-2:2013
ISO 7805-2:1987
Gulf Standard
Current Edition
·
Approved on
09 September 2013
Industrial plate screens -- Part 2: Thickness below 3 mm
GSO ISO 7805-2:2013 Files
English
5 Pages
Current Edition
Reference Language
You can buy this standard from any member store
GSO ISO 7805-2:2013 Scope
Abstract
Describes three patterns using round (circular) and square perforations. The sizes of holes range down to 2 mm for square holes and to 0.5 mm for round holes. Five ratios of pitch to hole are specified which result in nominal open areas ranging from about 60 % to 23 %.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
GSO 98:1988
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF
INTERIOR MATERIALS AND THEIR
TESTING METHODS
GSO 1780:2010
Gulf Technical Regulation
Motor vehicle-vehicle identification number (vin) - requirements
Recently Published from Mechanical Sector
GSO EN 13445-6:2024
EN 13445-6:2021
Gulf Standard
Unfired pressure vessels - Part 6: Requirements for the design and fabrication of pressure vessels and pressure parts constructed from spheroidal graphite cast iron
GSO ISO 11154:2024
ISO 11154:2023
Gulf Standard
Road vehicles — Roof load carriers
GSO ISO 10468:2024
ISO 10468:2023
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes
— Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors
Select GSO Member Stores
