GSO ISO 4427-3:2013
ISO 4427-3:2007
Gulf Standard
Current Edition
·
Approved on
09 September 2013
Plastics piping systems-Polyethlene (PE) pipes and fittings for water supply - Part 3: Fittings
GSO ISO 4427-3:2013 Files
English
31 Pages
Current Edition
Reference Language
You can buy this standard from any member store
GSO ISO 4427-3:2013 Scope
This part of ISO 4427 specifies the general aspects of fittings made from polyethylene (PE) for piping systems
intended for the conveyance of water for human consumption, including raw water prior to treatment and
water for general purposes.
It also specifies the test parameters for the test methods to which it refers.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
GSO 98:1988
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF
INTERIOR MATERIALS AND THEIR
TESTING METHODS
GSO 1780:2010
Gulf Technical Regulation
Motor vehicle-vehicle identification number (vin) - requirements
Recently Published from Mechanical Sector
GSO EN 13445-6:2024
EN 13445-6:2021
Gulf Standard
Unfired pressure vessels - Part 6: Requirements for the design and fabrication of pressure vessels and pressure parts constructed from spheroidal graphite cast iron
GSO ISO 11154:2024
ISO 11154:2023
Gulf Standard
Road vehicles — Roof load carriers
GSO ISO 10468:2024
ISO 10468:2023
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes
— Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors
Select GSO Member Stores
