GSO ISO 13203:2014
ISO 13203:2005
Gulf Standard
Current Edition
·
Approved on
25 December 2014
Chains, sprockets and accessories -- List of equivalent terms
GSO ISO 13203:2014 Files
English
25 Pages
Current Edition
Reference Language
You can buy this standard from any member store
GSO ISO 13203:2014 Scope
This International Standard establishes a list of equivalent terms, in English, French and German, related to the main mechanical chains, classified in accordance with their design and/or use, as well as their principal components, fittings and sprockets. It does not define terms.
It is applicable to the patterns of chains and components defined in the ISO standards referenced, as well as to many patterns of non-standardized chain that are used in special applications. As far as possible, the chains, sprockets and accessories are illustrated by an example.
NOTE In addition to terms used in English and French, two of the three official ISO languages, this International Standard gives the equivalent terms in German; these are published under the responsibility of the member body for Germany (DIN). However, only the terms given in the official languages can be considered as ISO terms.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
GSO 98:1988
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF
INTERIOR MATERIALS AND THEIR
TESTING METHODS
GSO 1780:2010
Gulf Technical Regulation
Motor vehicle-vehicle identification number (vin) - requirements
Recently Published from Mechanical Sector
GSO EN 13445-6:2024
EN 13445-6:2021
Gulf Standard
Unfired pressure vessels - Part 6: Requirements for the design and fabrication of pressure vessels and pressure parts constructed from spheroidal graphite cast iron
GSO ISO 11154:2024
ISO 11154:2023
Gulf Standard
Road vehicles — Roof load carriers
GSO ISO 10468:2024
ISO 10468:2023
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes
— Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors