GSO ISO 238:2015
ISO 238:1974
Gulf Standard
Current Edition
·
Approved on
03 September 2015
Reduction sleeves and extension sockets for tools with Morse taper shanks
GSO ISO 238:2015 Files
English
5 Pages
Current Edition
Reference Language
You can buy this standard from any member store
GSO ISO 238:2015 Scope
This International Standard lays down the dimensions of the following two pieces of equipment :
1) reduction sleeves for tools with Morse taper shanks;
2) extension sockets for tools with Morse taper shanks.
It comprises, for each of them, two tables giving respectively the dimensions in millimetres and the corresponding dimensions in inches.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
GSO 98:1988
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF
INTERIOR MATERIALS AND THEIR
TESTING METHODS
GSO 1780:2010
Gulf Technical Regulation
Motor vehicle-vehicle identification number (vin) - requirements
Recently Published from Mechanical Sector
GSO EN 13445-6:2024
EN 13445-6:2021
Gulf Standard
Unfired pressure vessels - Part 6: Requirements for the design and fabrication of pressure vessels and pressure parts constructed from spheroidal graphite cast iron
GSO ISO 11154:2024
ISO 11154:2023
Gulf Standard
Road vehicles — Roof load carriers
GSO ISO 10468:2024
ISO 10468:2023
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes
— Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors
Select GSO Member Stores
