GSO ISO 9943:2015

ISO 9943:2009
Gulf Standard   Current Edition · Approved on 03 September 2015

Shipbuilding -- Ventilation and air-treatment of galleys and pantries with cooking appliances

GSO ISO 9943:2015 Files

English 12 Pages
Current Edition Reference Language

GSO ISO 9943:2015 Scope

This International Standard specifies the design requirements and general considerations for the ventilation and air-treatment of galleys and pantries with cooking appliances onboard merchant seagoing ships, when such ventilation and air-treatment is specified by the shipowner. It applies for normal conditions in all waters except those encountered in extremely cold or hot climates (i.e. with a lower or higher temperature than those stated in 4.3 and 4.4). For the purposes of this International Standard, pantries with cooking appliances, referred to above, are those which contain appliances consuming more than the small amount of electrical power needed for coffee urns, hot-plates for keeping food warm, electric water boilers, etc. NOTE Users of this International Standard should note that, while observing its requirements, they should at the same time ensure compliance with such statutory requirements, rules and regulations as may be applicable to the individual ship concerned.

Best Sellers From Mechanical Sector

GSO 42:2015
 
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
 
Gulf Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS
GSO 98:1988
 
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF INTERIOR MATERIALS AND THEIR TESTING METHODS
GSO 1780:2010
 
Gulf Technical Regulation
Motor vehicle-vehicle identification number (vin) - requirements

Recently Published from Mechanical Sector

GSO EN 13445-6:2024
EN 13445-6:2021 
Gulf Standard
Unfired pressure vessels - Part 6: Requirements for the design and fabrication of pressure vessels and pressure parts constructed from spheroidal graphite cast iron
GSO ISO 11154:2024
ISO 11154:2023 
Gulf Standard
Road vehicles — Roof load carriers
GSO ISO 10468:2024
ISO 10468:2023 
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes — Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023 
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors