GSO ISO 11342:2015
ISO 11342:1998
Gulf Standard
Current Edition
·
Approved on
03 September 2015
Mechanical vibration -- Methods and criteria for the mechanical balancing of flexible rotors
GSO ISO 11342:2015 Files
English
39 Pages
Current Edition
Reference Language
You can buy this standard from any member store
GSO ISO 11342:2015 Scope
This International Standard presents typical flexible rotor configurations in accordance with their characteristics and balancing requirements, describes balancing procedures, specifies methods of assessment of the final state of unbalance, and gives guidance on balance quality criteria.
This International Standard may also be applicable to serve as a basis for more involved investigations, for example when a more exact determination of the required balance quality is necessary. If due regard is paid to the specified methods of manufacture and limits of unbalance, satisfactory running conditions can be expected.
This International Standard is not intended to serve as an acceptance specification for any rotor, but rather to give indications of how to avoid gross deficiencies and/or unnecessarily restrictive requirements.
The subject of structural resonances and modifications thereof is outside the scope of this International Standard.
The methods and criteria given are the result of experience with general industrial machinery. They may not be directly applicable to specialized equipment or to special circumstances. Therefore, there may be cases where deviations from this International Standard may be necessary1).
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
GSO 98:1988
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF
INTERIOR MATERIALS AND THEIR
TESTING METHODS
GSO 1780:2010
Gulf Technical Regulation
Motor vehicle-vehicle identification number (vin) - requirements
Recently Published from Mechanical Sector
GSO EN 13445-6:2024
EN 13445-6:2021
Gulf Standard
Unfired pressure vessels - Part 6: Requirements for the design and fabrication of pressure vessels and pressure parts constructed from spheroidal graphite cast iron
GSO ISO 11154:2024
ISO 11154:2023
Gulf Standard
Road vehicles — Roof load carriers
GSO ISO 10468:2024
ISO 10468:2023
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes
— Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors