GSO ISO 16742:2016
Gulf Standard
Current Edition
·
Approved on
22 December 2016
·
Iron ores -- Sampling of slurries
GSO ISO 16742:2016 Files
English
29 Pages
Current Edition
Reference Language
You can buy this standard from any member store
GSO ISO 16742:2016 Scope
This International Standard sets out the basic methods for sampling fine iron ore of nominal top size <1 mm that is mixed with water to form a slurry. At very high ratios of fine solids to water when the material assumes a soft plastic form (about 80 % solids depending on the particle size distribution of the solids), the mixture is correctly termed a paste. Sampling of pastes is not covered in this International Standard.
The procedures described in this International Standard apply to sampling of iron ore that is transported in moving streams as a slurry. These streams can fall freely or be confined in pipes, launders, chutes, spirals, or similar channels. Sampling of slurries in pressurized pipes is not covered in this International Standard. The slurry stream can only be sampled satisfactorily at a transfer point prior to the pressurized pipe at the end of the pipe when the slurry is no longer under pressure. In addition, sampling of slurries in stationary situations, such as a settled or even a well-stirred slurry in a tank, holding vessel, or dam, is not recommended and is not covered in this International Standard.
This International Standard describes procedures that are designed to provide samples representative of the slurry solids and particle size distribution of the slurry under examination. After filtration of the slurry sample, damp samples of the contained solids in the slurry are available for drying (if required) and measurement of one or more characteristics in an unbiased manner and with a known degree of precision. The characteristics are measured by chemical analysis, physical testing, or both.
The sampling methods described are applicable to slurries that require inspection to verify compliance with product specifications, determination of the value of a characteristic as a basis for settlement between trading partners, or estimation of a set of average characteristics and variances that describe a system or procedure.
Provided flow rates are not too high, the reference method against which other sampling procedures are compared is one where the entire stream is diverted into a vessel for a specified time or volume interval, ensuring that all parts of the stream are diverted into the vessel for the same period of time. This International Standard corresponds to the stopped-belt method described in ISO 3082. Reference increments have to be taken as close as possible to increments taken using the sampling procedure under evaluation.
Best Sellers From Construction and Building Sector
GSO 1431:2002
Gulf Technical Regulation
Sanitary appliances - pressurized flushing devices
GSO 1427:2008
Gulf Standard
Ceramic Sanitary Appliances - Western Water Closets
GSO 2084:2010
Gulf Standard
Design and application of speed control humps
GSO 2489:2015
Gulf Standard
Specifications of Recycled Aggregates from Construction
Waste to be used in construction Works
Recently Published from Construction and Building Sector
GSO ASTM E2129:2024
ASTM E2129:18
Gulf Standard
Standard Practice for Data Collection for Sustainability Assessment of Building Products
GSO EN 196-3:2024
EN 196-3:2016
Gulf Standard
Methods of testing cement - Part 3: Determination of setting times and soundness
GSO ISO 10563:2024
ISO 10563:2023
Gulf Standard
Building and civil engineering sealants — Determination of change in mass and volume
GSO ASTM C1074:2024
ASTM C1074:19e1
Gulf Standard
Standard Practice for Estimating Concrete Strength by the Maturity Method