GSO ISO 21940-11:2021
ISO 21940-11:2016
Gulf Standard
Current Edition
·
Approved on
01 July 2021
Mechanical vibration — Rotor balancing — Part 11: Procedures and tolerances for rotors with rigid behaviour
GSO ISO 21940-11:2021 Files
No files are available for this standard right now!
You can buy this standard from any member store
GSO ISO 21940-11:2021 Scope
ISO 21940-11:2016 establishes procedures and unbalance tolerances for balancing rotors with rigid behaviour. It specifies
a) the magnitude of the permissible residual unbalance,
b) the necessary number of correction planes,
c) the allocation of the permissible residual unbalance to the tolerance planes, and
d) how to account for errors in the balancing process.
NOTE In ISO 21940‑14, the assessment of balancing errors is considered in detail. Fundamentals of rotor balancing are contained in ISO 19499 which gives an introduction to balancing.
ISO 21940-11:2016 does not cover the balancing of rotors with flexible behaviour. Procedures and tolerances for rotors with flexible behaviour are dealt with in ISO 21940‑12.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
GSO 98:1988
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF
INTERIOR MATERIALS AND THEIR
TESTING METHODS
GSO 1780:2010
Gulf Technical Regulation
Motor vehicle-vehicle identification number (vin) - requirements
Recently Published from Mechanical Sector
GSO EN 13445-6:2024
EN 13445-6:2021
Gulf Standard
Unfired pressure vessels - Part 6: Requirements for the design and fabrication of pressure vessels and pressure parts constructed from spheroidal graphite cast iron
GSO ISO 11154:2024
ISO 11154:2023
Gulf Standard
Road vehicles — Roof load carriers
GSO ISO 10468:2024
ISO 10468:2023
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes
— Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors