GSO ISO 500-3:2021
ISO 500-3:2014
Gulf Standard
Current Edition
·
Approved on
01 July 2021
Agricultural tractors — Rear-mounted power take-off types 1, 2, 3 and 4 — Part 3: Main PTO dimensions and spline dimensions, location of PTO
GSO ISO 500-3:2021 Files
English
16 Pages
Current Edition
Reference Language
You can buy this standard from any member store
GSO ISO 500-3:2021 Scope
This part of ISO 500 specifies the manufacturing requirements for, and the location of, rear-mounted
power take-offs (PTOs) of types 1, 2, 3, and 4 on agricultural tractors.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
GSO 98:1988
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF
INTERIOR MATERIALS AND THEIR
TESTING METHODS
GSO 1780:2010
Gulf Technical Regulation
Motor vehicle-vehicle identification number (vin) - requirements
Recently Published from Mechanical Sector
GSO EN 13445-6:2024
EN 13445-6:2021
Gulf Standard
Unfired pressure vessels - Part 6: Requirements for the design and fabrication of pressure vessels and pressure parts constructed from spheroidal graphite cast iron
GSO ISO 11154:2024
ISO 11154:2023
Gulf Standard
Road vehicles — Roof load carriers
GSO ISO 10468:2024
ISO 10468:2023
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes
— Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors
Select GSO Member Stores
