GSO ISO 11154:2024

ISO 11154:2023
Gulf Standard   Current Edition · Approved on 14 October 2024

Road vehicles — Roof load carriers

GSO ISO 11154:2024 Files

GSO ISO 11154:2024 Scope

This document applies for roof racks of passenger cars and light commercial vehicles up to a permissible total weight of 3,5 t according to ISO 1176 and specifies requirements and test methods for these. It is also valid for roof racks mounted on trailers.

So-called magnetic or suction foot racks, i.e. roof racks whose attachment on the vehicle is only via magnetic forces or vacuum, are excluded from this document.

This document provides safety-related requirements under consideration of the weight, centre of gravity, air resistance and other safety-relevant properties for structures of roof racks for which no other technical or statutory regulations otherwise apply and which are not listed in 4.2. In individual cases, test requirements can extend beyond these requirements.

Best Sellers From Mechanical Sector

GSO 42:2015
 
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
 
Gulf Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS
GSO 98:1988
 
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF INTERIOR MATERIALS AND THEIR TESTING METHODS
GSO 1780:2010
 
Gulf Technical Regulation
Motor vehicle-vehicle identification number (vin) - requirements

Recently Published from Mechanical Sector

GSO ISO 10468:2024
ISO 10468:2023 
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes — Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023 
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors
GSO ISO 11114-5:2024
ISO 11114-5:2022 
Gulf Standard
Gas cylinders — Compatibility of cylinder and valve materials with gas contents — Part 5: Test methods for evaluating plastic liners
GSO ISO 4211-5:2024
ISO 4211-5:2021 
Gulf Standard
Furniture — Tests for surface finishes — Part 5: Assessment of resistance to abrasion