GSO ISO 11114-5:2024
ISO 11114-5:2022
Gulf Standard
Current Edition
·
Approved on
14 October 2024
Gas cylinders — Compatibility of cylinder and valve materials with gas contents — Part 5: Test methods for evaluating plastic liners
GSO ISO 11114-5:2024 Files
No files are available for this standard right now!
You can buy this standard from any member store
GSO ISO 11114-5:2024 Scope
This document specifies some gas compatibility test methods to evaluate plastic materials suitable for use in the manufacture of composite gas cylinder liners. It is also applicable to the evaluation of the suitability of plastic matrix materials used for Type 5 cylinders.
Some fluids like water, used for cylinders testing, can react positively or negatively when in contact with plastic liners. This compatibility issue is not covered by this document.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
GSO 98:1988
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF
INTERIOR MATERIALS AND THEIR
TESTING METHODS
GSO 1780:2010
Gulf Technical Regulation
Motor vehicle-vehicle identification number (vin) - requirements
Recently Published from Mechanical Sector
GSO ISO 10468:2024
ISO 10468:2023
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes
— Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors
GSO ISO 11114-5:2024
ISO 11114-5:2022
Gulf Standard
Gas cylinders
— Compatibility of cylinder and valve materials with gas contents
— Part 5: Test methods for evaluating plastic liners
GSO ISO 4211-5:2024
ISO 4211-5:2021
Gulf Standard
Furniture
— Tests for surface finishes
— Part 5: Assessment of resistance to abrasion