GSO ISO 24131-2:2024
ISO 24131-2:2023
Gulf Standard
Current Edition
·
Approved on
14 October 2024
Internal protection by polymeric lining for ductile iron pipes — Requirements and test methods — Part 2: Epoxy lining
GSO ISO 24131-2:2024 Files
No files are available for this standard right now!
You can buy this standard from any member store
GSO ISO 24131-2:2024 Scope
This document specifies the requirements and test methods applicable to factory applied internal epoxy lining for ductile iron pipes according to ISO 2531, ISO 7186 and ISO 16631.
It covers internal linings for use in the conveyance of raw water, potable water and sewage water for operating temperature up to 50 °C.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
GSO 98:1988
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF
INTERIOR MATERIALS AND THEIR
TESTING METHODS
GSO 1780:2010
Gulf Technical Regulation
Motor vehicle-vehicle identification number (vin) - requirements
Recently Published from Mechanical Sector
GSO EN 13445-6:2024
EN 13445-6:2021
Gulf Standard
Unfired pressure vessels - Part 6: Requirements for the design and fabrication of pressure vessels and pressure parts constructed from spheroidal graphite cast iron
GSO ISO 11154:2024
ISO 11154:2023
Gulf Standard
Road vehicles — Roof load carriers
GSO ISO 10468:2024
ISO 10468:2023
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes
— Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors
Select GSO Member Stores
