GSO ISO 10468:2024

ISO 10468:2023
Gulf Standard   Current Edition · Approved on 14 October 2024

Glass-reinforced thermosetting plastics (GRP) pipes — Determination of the ring creep properties under wet or dry conditions

GSO ISO 10468:2024 Files

GSO ISO 10468:2024 Scope

This document specifies methods for determining the ring creep properties for glass-reinforced thermosetting plastics (GRP) pipes. Properties include the creep factor and the long-term creep stiffness. Testing is performed under either wet (total immersion in water) or dry conditions.

Dry creep testing is typically performed for the assessment and control of raw material consistency. Wet creep testing is typically undertaken to determine the long-term creep performance in simulated use conditions.

Best Sellers From Mechanical Sector

GSO 42:2015
 
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
 
Gulf Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS
GSO 98:1988
 
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF INTERIOR MATERIALS AND THEIR TESTING METHODS
GSO 1780:2010
 
Gulf Technical Regulation
Motor vehicle-vehicle identification number (vin) - requirements

Recently Published from Mechanical Sector

GSO ISO 10468:2024
ISO 10468:2023 
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes — Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023 
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors
GSO ISO 11114-5:2024
ISO 11114-5:2022 
Gulf Standard
Gas cylinders — Compatibility of cylinder and valve materials with gas contents — Part 5: Test methods for evaluating plastic liners
GSO ISO 4211-5:2024
ISO 4211-5:2021 
Gulf Standard
Furniture — Tests for surface finishes — Part 5: Assessment of resistance to abrasion