GSO EN 13445-5:2021+A1:2024
EN 13445-5:2021+A1:2024
Gulf Standard
Current Edition
·
Approved on
14 October 2024
Unfired pressure vessels - Part 5: Inspection and testing
GSO EN 13445-5:2021+A1:2024 Files
No files are available for this standard right now!
You can buy this standard from any member store
GSO EN 13445-5:2021+A1:2024 Scope
This Part of this document specifies the inspection and testing of individual and serially produced pressure vessels made of steels in accordance with EN 13445-2:2021.
Special provisions for cyclic operation are given in Annex G of this Part.
Special provisions for vessels or vessel parts working in the creep range are given in Annex F and Annex I of this Part.
NOTE The responsibilities of parties involved in the conformity assessment procedures are given in Directive 2014/68/EU. Guidance on this can be found in CR 13445-7.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
GSO 98:1988
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF
INTERIOR MATERIALS AND THEIR
TESTING METHODS
GSO 1780:2010
Gulf Technical Regulation
Motor vehicle-vehicle identification number (vin) - requirements
Recently Published from Mechanical Sector
GSO ISO 10468:2024
ISO 10468:2023
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes
— Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors
GSO ISO 11114-5:2024
ISO 11114-5:2022
Gulf Standard
Gas cylinders
— Compatibility of cylinder and valve materials with gas contents
— Part 5: Test methods for evaluating plastic liners
GSO ISO 4211-5:2024
ISO 4211-5:2021
Gulf Standard
Furniture
— Tests for surface finishes
— Part 5: Assessment of resistance to abrasion