GSO BS 1710:2024
BS 1710:2014
Gulf Standard
Current Edition
·
Approved on
14 October 2024
Specification for identification of pipelines and services
GSO BS 1710:2024 Files
No files are available for this standard right now!
You can buy this standard from any member store
GSO BS 1710:2024 Scope
This British Standard specifies the colours and supplementary information for the identification of pipes conveying fluids in above ground and below ground installations. It also includes ducts for ventilation and conduits used for carrying electrical services.
The following two methods of identification are included:
- a) basic identification colours only; and
- b) basic identification colours and code indications and/or code colours.
NOTE 1 Examples of identification by basic colour and code indications are illustrated in Annex A.
NOTE 2 The marking and labelling requirements identified in this British Standard are the preferred methods where there is no British Standard that covers a specific pipe or pipeline sector.
This British Standard does not include identification of fluid services on ships.
NOTE 3 For piping systems on ships and marine technology applications, see BS ISO 14726.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
GSO 98:1988
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF
INTERIOR MATERIALS AND THEIR
TESTING METHODS
GSO 1780:2010
Gulf Technical Regulation
Motor vehicle-vehicle identification number (vin) - requirements
Recently Published from Mechanical Sector
GSO EN 13445-6:2024
EN 13445-6:2021
Gulf Standard
Unfired pressure vessels - Part 6: Requirements for the design and fabrication of pressure vessels and pressure parts constructed from spheroidal graphite cast iron
GSO ISO 11154:2024
ISO 11154:2023
Gulf Standard
Road vehicles — Roof load carriers
GSO ISO 10468:2024
ISO 10468:2023
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes
— Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors
Select GSO Member Stores
